Hinds 111 has a single touch panel which connects all of the classrooms monitors and inputs into one easy to use touch screen.

The primary screen which will be displayed at the beginning of a session is shown below.

Extron TouchPanel System Settings

Note: When "System Off" is selected the classroom takes approximately two minutes to shut down everything and then reboot for operation.

Main Display Controls

Power - Main power controls for the projector display at the front of the room.
Main Display Settings - The options here are PC Monitor Display, HDMI, and 5 alternative HDMI options with ports throughout the room {The HDMI Inputs are located on the walls near outlets}. Touch any of these while highlighting your desired display above (Left/Projector/Right) to change.
To ALL - By touching this option, the display/volume settings currently selected will be pushed TO ALL other display settings on this Extron system.

If video is not outputting and you have consulted the above options, make sure video mute is NOT highlighted.

Main Volume Settings - Up and Down arrows will raise volume for the speakers throughout the classroom.
Main Microphone Settings - Up and Down arrows will raise input sensitivity of the microphones throughout the room (When they are in use).

Teaching Station Monitor - Similar to the above display options, these will change the output of the monitor on the teaching station relative to the highlighted option.
Left Screen / Right Screen - Control the projector screen(s) located in the front of the classroom.
Lights Presets - Control the lights for the entire room.

Confidence Monitor - Select this option to open up the following display which allows for control of the two monitors located on the back wall.

Left Rear/Right Rear - Selecting the options below these headings will change the display of the back-wall monitors.

Unable to render {children}. Page not found: Instructional Technology Resources.