111 has a single touch panel which connects all of the classrooms monitors and inputs into one easy to use touch screen.

The primary screen which will be displayed at the beginning of a session is shown below, and has two primary options - "Dual Projectors" and "Projectors and Monitors"

Projector and Monitor Operation

Selecting the "Dual Projectors" option displays the Local PC onto the left and right projectors mounted to the ceiling.  

Selecting the "Projectors and Monitors" option displays the Local PC onto the left and right projectors, as well as the center monitor located between the projectors and the two monitors in the back of 111.

When either initial option is selected the touch screen will display the screen shown below - the following sections describe all of the functionalities.

Adding Monitors or Projectors

If specific monitors or projectors want to be turned on or off there are "Projector Control" and "Monitor Control" options located at the bottom of the touch screen under "Utilities," as shown in the image below.

Projector Control

When "Projector Control" is selected the following page is displayed with all of the options. 

The left and right projector can have the power and aspect ratio altered directly from the Extron panel.  

Monitor Control

When "Monitor Control" is selected the following page is displayed with all of the options.

The monitors can be individually turned on or off, and can swap between the inputs (Local PC or Laptop).

Laptop Operation

At the top of the teaching podium there is a VGA with audio connection for professors to display their own laptop onto the classroom monitors and projectors.  

The VGA cable with the audio attachment is shown in the image below.

Connect the device and then select "VGA Port" on the Primary screen, as shown below. 

Now the laptop will be displayed on the selected monitors and projectors.

Volume Control

The volume for either the local PC or laptop can be raised or lowered by the right hand volume control panel.  

To increase the volume of the room speakers tap the larger speaker icon, as highlighted in the image below.

To lower the volume of the room speakers tap the smaller speaker icon at the bottom, as highlighted in the image below. 

Support

If there are any questions feel free to contact the iLab Consultants located in room 011a, or by phone at 443-5025.

Shutdown and rebooting

To shutdown the system after use hit the "System Off" button in the bottom right corner of the Extron display, as shown below.

When the system is shutting down the screen shown below will be displayed.

Note: When "System Off" is selected the classroom takes approximately two minutes to shut down everything and then reboot for operation.