Keyboard and mouse (wireless)
- A wireless keyboard and mouse are located inside the locked closet (accessible with the same room key) by the window.
- No setup is necessary. If either device does not respond, try replacing the battery (spare batteries are available in the cabinet inside the locked closet by the window).
- Located on the wall to the left of the HD Display Screen, this is used to control the input of the devices available in the room.
- An HDMI and two USB ports (one is used by the wireless keyboard and mouse in the room) are available.
Microphone (wireless handheld, lapel, room)
- Wireless handheld and lapel microphones are located in the drawer inside the locked closet by the window.
- Hold down the Power/On-Off button for a few seconds to turn on and off.
- Microphones should be on the 566.600 MHz frequency (as noted on the receiver in the locked closet).
- Remember to turn microphones off to preserve batteries.
- Replacement batteries are located in the same drawer as the microphones.
- Microphone volumes can be adjusted via the Media Controller panel under Mic. Volume.
- Room microphone is located on the ceiling of the room and available through videoconferencing software (Microsoft Teams, Zoom etc...) when using the Presenter PC.
- Additional/relevant information located here.
Network (wired, wireless)
- An Ethernet cable is available in the locked closet by the window. Ports are located on the wall below the Media Controller, closer to the floor.
Presenter PC
- A Windows PC is available inside the locked closet by the window.
- You can log in using your NetID and password or via the Guest account.
- Software list
Anchor |
---|
| videoconference |
---|
| videoconference |
---|
|
Videoconferencing software settings
- When using videoconferencing software, the device settings should be set as followed:
- Camera – PTZ Pro 2
- Speaker – ExtronScalerD
- Microphone – Microphone (USB Audio CODEC)