Versions Compared

Old Version 7

changes.mady.by.user Andrew Wowelko

Saved on

compared with

New Version 8

changes.mady.by.user Andrew Wowelko

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Figure 1_Assisted Listening SystemImage RemovedRecently upgraded LEMP registrar rooms include

Registrar classrooms currently use two different models or Assisted Listening Systems.

These systems send all audio being projected in the rooms speakers, to individual body pack receivers that can be worn by users with hearing disabilities. Users have the ability to control volume and listen through an earpiece (3.5mm jack) that is connected to the body pack receiver. 

Table of Contents

 

 

Operating the Assisted Listening Receiver

To operate the Assisted Listening Receiver use the following instructions:

  • Turn on the technology system
  • Locate the receiver, which can usually be found in a drawer on the teaching station or in the technology rack. (See: Figure 2_ALS Receiver) 
    Figure 2_ALS ReceiverImage Removed
  • Additional receivers can be provided by contacting the building administrator or by request at 315-443-2677
  • In the drawer, there should be a receiver, an earpiece, and AA batteries to power the receiver.
  • Connect the earpiece (3.5mm) in the audio jack found on the top of the receiver (See: Figure 2.1_Als Receiver_Top View)
    Figure 2.1_Als Receiver_Top ViewImage Removed
  • The Receiver should now appear as follows (See: Figure 2.2_ALS Receiver_Ear Piece):
    Figure 2.2_ALS Receiver_Ear PieceImage Removed
  • Make sure batteries are properly installed by opening the front cover of the receiver, by pressing the side of the cover and pulling down. (See: Figure 2.3_ALS Receiver_Batteries)
    Figure 2.3_ALS Receiver_BatteriesImage Removed
  • Turn the Volume Reel to the left to turn on the receiver (See: Figure 2.1_Als Receiver_Top View)
    • Turn to the left to increase volume and turn to the right to decrease volume, or turn of the receiver
  • Use the Channel Select Buttons to make sure the receiver is set to the right frequency  (See: Figure 2.1_Als Receiver_Top View)
    • The front display of the receiver will show what channel it is currently set to. 
    • The frequency can be found by looking at the upper left corner of the touch panel or by looking at the transmitter in the technology rack (See: Figure 3_Control Panel_ALS)
    Figure 3_Control Panel_ALSImage Removed 

    Thes systems use either Radio Frequency (RF) or Infrared (IR) technology. Please select the model that is present in the classroom you are looking for instructions.


    Panel
    bgColor#d9d9d9
    borderWidth0 px

    IR Systems

    IR ALSImage Added

    Panel
    bgColor#d9d9d9
    borderWidth0 px

    RF Systems

    RF ALSImage Added


    If the ALS receiver does not function as described please call 315-443-2677 for assistance.