...
VARIABLE SPEED CONTROL (Models 360VS and 362VS Only) Models 360VS and 362VS have Variable Speed Control. The operating speed is adjustable between 1000 SFM (surface feet per minute) and 1500 SFM. Adjust the speed by turning the thumbwheel (C) Fig. 2. Thumbwheel position #1 provides the slowest operating speed (1000 SFM) while position #6 provides the fastest operating speed (1500 SFM). The speed can be changed with the motor running or not running. A C B
Tracking the Abrasive Belt (See Fig.3)
...
- Turn the tool over, rest the tool on its front handle, and grasp the rear handle with your left hand. Rest your ring finger and little finger on the trigger (Fig. 3).
- Start the motor by squeezing the trigger.
- Turn the belt aligning screw (A) Fig. 3 in either direction until the edge of the belt is even with the outer edge of the rear rubber covered pulley. The edge of the belt will extend beyond the edge of the front pulley.
- Turn the motor “OFF” and allow the sander to come to a COMPLETE STOP before turning it right side up.
...